Hallo, habe die dm920 mit BCM45208 Tuner .Nun zum Problem ,beim erstmaligen Flaschen der Box fing beim hochfahren der Box das
Bild ständig an zu flackern,auch nach der ersteinstellung bzw. Konfiguration Kling das flackern nicht weg.Dann wieder in den rescue mode neu geflasht,das gleiche Problem ,dann noch einmal neu geflasht,auch nix.beim dritten Flaschen endlic/ geschafft.kann es sein das der Tuner defekt ist?image eingerichtet alles gut.
Dann kam zwei Tage später d.h. am 8 dec . Ein Update und ich dachte das es wohl daran liegen könnte und neu geflasht und genau das gleiche Problem ! Bitte um Hilfe
Flash Probleme dm920
-
-
Was flackert? Nur das TV-Bild oder die gesamte Darstellung am Fernseher? Oder das OLED an der Box?
-
....das TV Bild, auch wenn ich in den Einstellungen oder in den Erweiterungen d.Box bin ,dies Problem hatte ich mit meiner dm900 hd nie!
-
Hdmi-Kabel steckt gut? Evtl. eine nicht-unterstützte Bildeinstellung?
-
....hatte ich auch zuerst gedacht,ist aber ok!
-
Danke dre lag am hdmi Kabel
-
schön, dass du die Fehlerquelle gefunden hast. Leider denkt man oft sowas banales wie ein Kabel kann nicht die Ursache sein. Aber grad bei HDMI ist das leider immer öfter der Fall und das nicht nur bei den billigen Kabel.
-
Hi
i have a problem with my dm920.
when try the recovery my box go in crash.
go in crash when:
reboot
recovery mode
rename somethin in broswer file
or other......
the crash say's:
unable to write etc\enigma2\setting read only filesistem
unable to write etc\enigma2\timer.xml read only filesistem
read only filesystem etc\enigma2\blacklist
Help
Please!!!!!
-
Flash an up-to-date unstabile Image from DP or OoZooN and Not the stabile.
-
i'm try to flash but isn't possible go in recovery mode or force recovery with button on board of the box.....
-
Then watch the e2world Video how to Press the Button, use Menü Interface or to-the-rescue command in telnet or ssh
-
Take a look at the timing.
Use the same hand to switch on, an press the sensor key. Like here ----> https://www.youtube.com/watch?v=v-I_EkMWLf0
After show a [ ! ] in the display, you can release the sensor key.
-
thanks for the tutorial.
but I tried several times with this method and the box turns on normally. -
The timing it's a little bit difficult, i think you will try sometimes more.
You may not so fast go from the hardware switch to the sensor key.
The sensor key is working to switch the box normally on ?
-
-
You can also use only
to-the-rescue
it's easier.
-
-
You can also use only
to-the-rescue
it's easier.
It is. But that command was implemented later and is maybe not available in stable images. AFAIK...
I don't know any english tutorial. This one is german, but contains a lot of screenshots. That might help
-
If you do an online Software Update in stabile Image command should be There.
If you Install dBackup Plugin the Standard web Interface has a Rescue Loader boot Option in Power Menü and you even could Flash images without Rescue Loader.
If you Install DreamFlash Plugin you can Update the Rescue Loader and Flash via USB Stick,....
-
thank you
With the software for the telnet connection I managed to enter the recovery mode and flash the first box with the backup of the second box I have ...Thank you