I have an intermittent problem with my DM8000 where I am using a PCMCIA card and cam (for Australia Vast) but when I change channels, it freezes and have no way to access any ports or IP. picture just locks up and the remote is ignored.
also cannot boot with cam inserted in any of the slots. Freezes!
routine is as follows,
1) Change channel>locked up,
2) switch off at the back, remove cam,
3) switch back on,
4) wait for complete system reboot and then once settled, reinsert cam, if lucky all good, if not, remove cam and start over again! but wait a little longer, at least until the unit is settled on a channel
using OPLi (nightly 6/01/2022),
Is there any way to diagnose this or software that could be used maybe?
Replaced the HDD very recently but no effect for this issue.
any thoughts appreciated.