Please provide some information about the hard- and software used.
Box type: 7025
GUI (enigma1/enigma2): believe it's Enigma 2, but don't know for sure
Firmware version: don't know
your question
Hi. I have a problem with 7025. Here's what i did. DB arrived, yey! Plugged it in and turned it on. There was no start wizzard which was supposed to show up. Then there was a messege that i should do a service search. Did that via automatic mode, and it found more than 1000 services and the channel list is full, but none of the channels show up, all i see is DB background and 'waiting for event data' on the info bar, no matter is it fta or pay channel. Connected it to my pc. Switch box on while pressing the under arrow... Box writes DHCP and doesn't give me an IP address, it says:
dhcp
flash/vmlinux.gz
Ok, then i've set the ip adress manually in setup. I can ping it, but can't access it - i can't use DreamUp with only nullmodem cable, i have to use the crossover cable also, otherwise i can't even ping it. In DreamUp, i start the connection and it says 'turn on dreambox', so i do it but but nothing happens. With hyperterminal, i can access it via telnet, but it says nothing's there and i can't se the boot menu. I can FTP it without any problems.
Also, in satelite config, it was already preconfigured for two LNB's, even though i have onla one LNB tuned to Astra. At first they were set to Simple, DiSEqC AB, Astra, Eutelsat but since it din't work i changed it to simple, single, astra for both sockets. Nothing. I can't set Socket B to 'Same as socket A' or 'nothing connected' or any other option stated in the manual.It just says SocketB: Alps BSBE 702A (DVB-S), tha same as in socket A.
And the box yis pretty hot.
Help me