Beiträge von Lurker


    I did that already, but it doesn't show an ip address. It just sasy 'dhcp flash/vmlinux.gz' and after a whle it goes away.



    Zitat

    Originally posted by el_tonno
    Just type the ip-adress in your favourite browser and you will see the webif of the bootloader.


    Then click on the link "firmware update" or somwhere in the text and upload the nfi-file.


    When the flash process has finished, you can reboot the box.


    Then i've set the ip via setup menu, and i can ping it, telnet, and transfer files up & down via ftp. But when i enter that ip address i the explorer, i get 'The page cannot be displayed'

    To be honest, it never occured to me that the cable might be faulty, but now that you mentioned it, it could be. I tried with both port combinations and nothing. I also tried with tcpip and it connects to the box, and i login as root, but the box says there's nothing there. Didn't remember the exact outoput, but it pretty much says it can't find anything. Yet, ftp-ing shows lot of files.


    Also, is it normal for the box to be hot? It didn't burn my skin, but it was pretty hot.

    Please provide some information about the hard- and software used.


    Box type: 7025
    GUI (enigma1/enigma2): believe it's Enigma 2, but don't know for sure
    Firmware version: don't know


    your question



    Hi. I have a problem with 7025. Here's what i did. DB arrived, yey! Plugged it in and turned it on. There was no start wizzard which was supposed to show up. Then there was a messege that i should do a service search. Did that via automatic mode, and it found more than 1000 services and the channel list is full, but none of the channels show up, all i see is DB background and 'waiting for event data' on the info bar, no matter is it fta or pay channel. Connected it to my pc. Switch box on while pressing the under arrow... Box writes DHCP and doesn't give me an IP address, it says:


    dhcp
    flash/vmlinux.gz


    Ok, then i've set the ip adress manually in setup. I can ping it, but can't access it - i can't use DreamUp with only nullmodem cable, i have to use the crossover cable also, otherwise i can't even ping it. In DreamUp, i start the connection and it says 'turn on dreambox', so i do it but but nothing happens. With hyperterminal, i can access it via telnet, but it says nothing's there and i can't se the boot menu. I can FTP it without any problems.


    Also, in satelite config, it was already preconfigured for two LNB's, even though i have onla one LNB tuned to Astra. At first they were set to Simple, DiSEqC AB, Astra, Eutelsat but since it din't work i changed it to simple, single, astra for both sockets. Nothing. I can't set Socket B to 'Same as socket A' or 'nothing connected' or any other option stated in the manual.It just says SocketB: Alps BSBE 702A (DVB-S), tha same as in socket A.


    And the box yis pretty hot.



    Help me :frowning_face: