Please provide some information about the hard- and software used.
Box type: DB7025
GUI (enigma1/enigma2): enigma2
Firmware version: latest
your question: Does anybody have a QPH-031 LNB going through a DISEqC switch and through a SG2100 motor down to the receiver? How did you setup your DB? I have tried every avaialble option there and none of them gets the motor to work. I have other rcvrs here that zip from sat to sat and track them fine. So, I am sure the motor is working and tracks the belt fine. But what is the trick to get the DB to understand the setup?
The motorized setup interface needs some serious revamping. It is not logical at all!?!?
In one place under the simple setup, when you switch the diseqc mode to positioner, which I am guessing is referring to a motor, it asks for lat and long values. in my case, my long. is 121 which needs three digits before the decimal mark. DB by default has only 2 digits there and there is no way to edit the value and move the decimal to the third digit !?!?!? so my long comes as 12.1 instead of 121????
I thought that this device was built to be used globaly?!?!?!?!?