Is it possible to add an option to internal loop through mode to choose SCR channel?
It will be very helpfull for new twin tuners combined with unicable lnb.
Choise of unicable channel in loop trough mode tuner
-
Yes but you have to switch to extended/expert configuration.
-
Yes but you have to switch to extended/expert configuration.
I did it.
But there is a conflict if you use disceq 1.2 motor.
Dreambox allow to zap to other satellite even you are recording something. This is not happend when you use universal lnb with internal loop trough option !
Unicable lnb are used by a lot of people. I think it intersting to add lnb option to all simple mode ! -
Ghost already told you:
Unicable + DiSEqC Rotor is not a supported configuration!
There's just no point in doing so! Anytime one Box turns the rotor the other would have to turn it back OR be without signal. -
Ghost already told you:
Unicable + DiSEqC Rotor is not a supported configuration!
There's just no point in doing so! Anytime one Box turns the rotor the other would have to turn it back OR be without signal.I success to do it, by setting disceq 1.2 configuration only in master tuner.
In slave tuner I used advanced configuration and I set disceq to none.
To force dreambox to use master tuner I set high priority on it and low priority on slave tuners.
To answer you remark, It is surely possible to support unicable+ disceq rotor, because it is the same problem with universal LNB !
