The same for me please.
For dm920.
Gutemine feeds blocks dreambox updates. When I desintalle it, it removes also the quadpip plugin.
Please share with us the .deb file
The same for me please.
For dm920.
Gutemine feeds blocks dreambox updates. When I desintalle it, it removes also the quadpip plugin.
Please share with us the .deb file
Ghost already told you:
Unicable + DiSEqC Rotor is not a supported configuration!
There's just no point in doing so! Anytime one Box turns the rotor the other would have to turn it back OR be without signal.
I success to do it, by setting disceq 1.2 configuration only in master tuner.
In slave tuner I used advanced configuration and I set disceq to none.
To force dreambox to use master tuner I set high priority on it and low priority on slave tuners.
To answer you remark, It is surely possible to support unicable+ disceq rotor, because it is the same problem with universal LNB !
Yes but you have to switch to extended/expert configuration.
I did it.
But there is a conflict if you use disceq 1.2 motor.
Dreambox allow to zap to other satellite even you are recording something. This is not happend when you use universal lnb with internal loop trough option !
Unicable lnb are used by a lot of people. I think it intersting to add lnb option to all simple mode !
Is it possible to add an option to internal loop through mode to choose SCR channel?
It will be very helpfull for new twin tuners combined with unicable lnb.
I found a temporary solution. Setting master tuner with high priority and slaves with low priority and disceq set to none !
i dont understand what you try to tell me...
rotor?!?! i think you have unicable...
you have a unicable LNB on motorized dish? this is no usable configuration
Exactely, unicable LNB on motorized dish.
It is why I suggest to add an option in internal loop through to select lnb channel
Hi,
for unicable with two different SCRs you have to use the advanced mode.
There you can enable the linked to option and choose a different SCR for the 2nd channel.
I tryed this solution, but it make rotor conflict.
If i define disceq 1.2 in tuner A2, rotor will be used even tuner A1 is occupied. If it is disabled in tuner A2, dreambox don't force disceq on zapping some times because it happen that it prefer using tuner A2
I tested yeasterday inverto unicable lnb with new twin tuner on dreambox 7020 HD.
When I configure tuner A2 with internal loop through I can not see two
channel in the same time because there is a SCR channel conflict. When I
choose advanced mode, it works but I have a disceq 1.2 motor orders
conflict.
It possible to add an option to internal loop through mode to choose SCR channel ? Or there is an other solution ?
Regards