Hi @ll,
I have the following problem, which started about 4 days ago. The box does not boot after it was put in Deep standby.
The display goes on, but there is no boot menu, nor is there the usual sound that the hard disk makes during the boot. The display remains then on, but only in blank, so nothing written in the display, and if you click on the power button it goes off, and if you click again on the power button the display goes on again, but that is the only thing it does. It still does not boot.
After removing it from power and waiting some time and switching it on and off several times on, it suddenly booted.
Today it started again with the same behaviour, after switching it on it only showed again the display only but no boot. After several switch on, switch off, using also the interrupt button at the back of the box, after about 10 minutes it showed the boot menu and the box booted.
So my question is now, what is wrong with the box?
Why does it not boot when switched on and only after several attempts, using the button at the back of the box it finally boots?
When I saw the problem 4 days ago, I thought maybe the software needed an update, so upgraded to the box to the latest firmware:
Enigma 2010-12-16-3.0
Image: Release 3.0.3 20q0-12-16
But still today I had the same problem back, so this is more a hardware problem.
What should I do?
[Update] The box is 4 years old now, was purchased in December 2006.