BIG problem with new 7025+

    My new 7025+ don't works correctly with my StabHH120 (with my 7000s same installation it's perfect!)


    The power supply "noise" ago when the moving stab (any satellite) and the channels into high band (>11700) not seen good! The signal oscillates from 13db/0ber to 0db/18000ber (with channel into low band no problems) and the vision it's impossible!


    WHY ?? the power supply Is not very powerful???


    HELP ME!

    dm500 - dm7000 - dm7025 - dm800 - dm8000

    I have a SG2100 rotor from moteck.


    The current in the lnb-setup is min. 100mA.
    With my dm7000 i had to insert 85 mA for the current.


    With the 100 mA-settings i have no problems with the rotor.


    Try different values.

    excactly - this is not only a question of power - guess what the Rotor settings to enable fast/slow move, using power to verify location,... are good for ?

    Zitat

    Originally posted by gutemine
    excactly - this is not only a question of power - guess what the Rotor settings to enable fast/slow move, using power to verify location,... are good for ?


    Sorry but it's only a question of power because:


    -I tryed ALL mA settings (15->100 mA) anda slow/fast speed
    -I tryed another receiver: one simple 7025 (not "plus") and it's ALL OK (no problems with 50 mA and fast speed)
    -The location settings it's ok!


    Thanks

    dm500 - dm7000 - dm7025 - dm800 - dm8000

    2 Mal editiert, zuletzt von eagle ()

    I have also installed my Moteck SG2100A yesterday and connected it to my DM7025+ and mostly i have to zap 2à3 times on a satellite before it startst moving.
    On tuner A I have a dish with 4 lnb's and on tuner B it's now the motor
    I also have tried different kind of settings but no succes.
    Who can give me another hint please?

    Zitat

    Originally posted by rytec
    I have also installed my Moteck SG2100A yesterday and connected it to my DM7025+ and mostly i have to zap 2à3 times on a satellite before it startst moving.
    On tuner A I have a dish with 4 lnb's and on tuner B it's now the motor
    I also have tried different kind of settings but no succes.
    Who can give me another hint please?


    I try already since 4 weeks to get my SG2100 A working with the new 7025+,
    but noppes ..................... was working always fine before with 7000S.