does anybody encounter this problem with dm5600 box, it doesn't boot. it shows only dm 5600 boot in the LED display.
i already tried many images (images for dm5600 and dm5620) but still nothing happens after flash.
the flash was all successful and no error.
even i wait 30 minutes still LED display shows dm 5600 boot.
dm5600 boot problem
-
-
the 7000 shows the same behavior sometimes...
in this case it helps to leave the box in power off state (no power cable connected) for a few hours
no joke! -
thanks digi_casi i will try your advice
-
i leave the box in power off state(no power cable connected) and no other cable connected to the box for a couple of days(around 3days) and try to load official image that was fresh download from the official site but still it did not solve the boot problem.
i read some topic in and use hyperterminal to see whats happening while the box is in boot. see attach file....
--- Device Configuration ---
Power-On Test Devices:
000 Disabled System Memory [RAM]
002 Disabled Ethernet [ENET]
----------------------------
Boot Sources:
001 Enabled Application in Flash [FLASH]
002 Disabled Ethernet [ENET]
local=0.0.0.0 remote=255.255.255.255 hwaddr=0009341e9196
003 Disabled Serial Port 1 [S1]
Baud = 9600
----------------------------
Automatic Boot: Enabled
----------------------------
1 - Toggle Power-On Tests
2 - Change a Boot Device
3 - Change IP Addresses
4 - Ping test
5 - Change Baud Rate for S1 Boot
7 - Toggle Automatic Boot
D - Display Configuration
S - Save Changes
0 - Exit Menu and Boot Application
-> -
-
Load the erase image and try again.
-
thanks digi_casi .it good info for me.