Tune Failed

    TUNE FAILED ! this problem still not fixed.


    Is anyone addressing this?


    Rotor movement usually fails if tuner B is set to "Equal to Socket A" or "Second Cable of Motorized LNB". There are some conditions where this works, but so far I have not determined the circumstances; it may depend on the direction of travel, the polarity of the destination channel, or some other factor.


    I have a normal stab-motor configuration with one LNB.


    It is very annoying that it always fail to turn to satellites.
    I always get the pop-up...... TUNE FAILED.......


    So i have to tune to other satellites first and than to the wanted sat.
    Impossible for the moment to program multi-satellite recordings!!!!!!


    I hope there will be a solution soon for this problem.


    Sincerely,

    Same problem for me. I have additional info.


    Iam watch a channel at tuner A at 19E. Iam switching to 28,2. It switch first to tuner B and then it is trying to rotate. After a few seconds I got the message "tune failed"


    Should it stay at Tuner A. Iam not recording anything.


    LM

    Same problem here..
    Obviusly a software error, if the configuration of tuner B is set to nothing attached, for instance, the problem doesn't occur.
    Come on guys, this shouldn't be too hard to fix ?!?


    The problem is a known bug for over 5 months now.