Please provide some information about the hard- and software used.
Box type:db500s
GUI (enigma1/enigma2):
Firmware version:
I have two questions; one about how to hook up the Perfect Vision PVMS5X8A powered multiswitch to the cables and one question on how to set up the Dreambox to switch the multiswitch.
I have very long cable runs and therefore have lower signal strength on the PPV channels. I bought a powered multiswitch by Perfect vision that has 5 inputs and 8 outputs. The multiswitch inputs are marked 18v, 13v, 18v 22khz and 13v 22khz. I use two different sat dishes. One is pointed at Dish110 and the other at BEV91. Each dish has a dual LNB so there are two cables running from each dish. I am connecting the two Dish110 cables to 18v and 13v respectively. The two Bev91 cables are connected to 18v 22khz and 13v 22 khz respectively. I am only using one output as I only have one receiver.
Does anyone know if the Dreambox can use this multiswitch? Is this cabling arrangement correct?
Now, on the Dreambox setup, Satellite configuration; since I am not using a diseqc switch how do I setup the top selection? Do I choose "2 satellites with toneburst" or "2 satellites via 22khz"?
Any help would be appreciated.