Please provide some information about the hard- and software used.

Box type: DM7000
GUI (enigma1/enigma2):
Firmware version:

your question

i bought my dm7000 in october 2002 and worked perfectly up to
yesterday night while watching an HB 13east channel the image disappeared
and the signal strenght went to 0 (45%).

My configuration is external stab rotor HH120 , 115 cm antenna and an
added internal switching power-supply for the 80Gb hard disk.

Strange, i found after the fault the rotor positioned at about 35deg east
it moved by itself.

Now the dm7000 cannot command anymore the rotor.
I than disconnected the motor and connected directly LNB and dm7000
pointed to HB at 13 east.

The voltages for LNB are exiting correctly but with a sat-scan i can have a
lock only in one -trasponder-signal.

Apparently i got a degradation in reception related with diseq (the motor)
and up to now i did not notice any UCO error.

Anyone got a similar failure ? any suggestion before opening the box ?

regards cnrifsi