Ich habe versucht, den USB-Wlan-Adapter der Dreambox 7080 HD an zwei Linux-PCs mit Ubuntu Linux 14.04.2 (kernel 3.13.0-44-generic) ausprobiert. Bei beiden wird mir angezeigt, daß das WiFi-Modul per Hardwareschalter deaktiviert ist:
Code
$ rfkill list
0: phy0: Wireless LAN
Soft blocked: no
Hard blocked: yesDas ist natürlich Quatsch, weil es keinen Hardwareschalter gibt.
Weiß jemand, was ich machen muss, um das Ding nutzbar zu machen?
dmesg gibt folgendes aus:
Code
[ 181.642421] usb 2-6: new high-speed USB device number 3 using ehci-pci
[ 181.777036] usb 2-6: New USB device found, idVendor=07b8, idProduct=8188
[ 181.777047] usb 2-6: New USB device strings: Mfr=1, Product=2, SerialNumber=3
[ 181.777054] usb 2-6: Product: RTL8188S WLAN Adapter
[ 181.777060] usb 2-6: Manufacturer: Manufacturer Realtek
[ 181.777065] usb 2-6: SerialNumber: 00e04c000001
[ 181.885144] cfg80211: Calling CRDA to update world regulatory domain
[ 182.063060] cfg80211: World regulatory domain updated:
[ 182.063070] cfg80211: (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
[ 182.063076] cfg80211: (2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[ 182.063082] cfg80211: (2457000 KHz - 2482000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[ 182.063087] cfg80211: (2474000 KHz - 2494000 KHz @ 20000 KHz), (300 mBi, 2000 mBm)
[ 182.063092] cfg80211: (5170000 KHz - 5250000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[ 182.063096] cfg80211: (5735000 KHz - 5835000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[ 182.089927] rtl8192cu: Chip version 0x10
[ 182.256724] rtl8192cu: MAC address: 40:7b:17:03:4d:61
[ 182.256735] rtl8192cu: Board Type 0
[ 182.257093] rtl_usb: rx_max_size 15360, rx_urb_num 8, in_ep 1
[ 182.257170] rtl8192cu: Loading firmware rtlwifi/rtl8192cufw_TMSC.bin
[ 182.257356] usbcore: registered new interface driver rtl8192cu
[ 182.327803] r8712u: module is from the staging directory, the quality is unknown, you have been warned.
[ 182.329606] usbcore: registered new interface driver r8712u
[ 182.343005] ieee80211 phy0: Selected rate control algorithm 'rtl_rc'
[ 182.343748] rtlwifi: wireless switch is on
[ 182.408399] IPv6: ADDRCONF(NETDEV_UP): wlan0: link is not ready