I can't set up my rotor correctly wtih two twin LNB:s connected.
Tuner A is connected to 2-way switch and then to the rotor.
Tuner B is directly connected to the two LNB:s via a 2-way switch.
I have 6 degrees separation of the two twin LNB:s so I can rapidly switch between 19E / 13E, and 5E / 1W.
To be able to use the switch for two sat-positions I have set up my box to store the same position for the rotor on 1W / 5E and 13E / 19E.
Thus, I'm not using USALS.
However, I find it impossible to find a good setup for tuner B.

If I set it as "second cable from motor" I'm not able to record/watch from more than one satellite position at a time.
All other satellites are greyed out and unavailable. This is not good!
The rotor works correctly, though.
If I set it to be "same as A" the rotor doesn't work because it tries to tune in on a different satellite on tuner B all the time.
It's only tuner A that is connected to the rotor.
I was thinking of getting a 4-way switch and somehow conect both tuners to the
rotor, but I don't know how that can be done? I don't think it's possible.

I think the only solution is a firmware fix which allows satellites which are stored on the SAME rotorpostion to be watched and NOT greyed out as it is today.
Please give me your thoughts about this.

Cheers,
-Mac