hi to all,

suddenlty my dream (original) DM800 stop boot.

after put it on power

dchp...
/flash/vmlinux.gz

says but after a while the front panel just switch off.

only the rear LAN lights keeps on but nothing happens

any ideas?

thanks in advance

Hi to all and merry Christmas
I have a DM800 and i have all ready connect successfully an internal 2.5 SATA HD .
Now i want to connect a USB HD.
I plug it into the USB port but it does not "doing" something.
Do i have to do something else?

Thanks in advance

Ok for the 13,19,28 but when i am watching on 39 and trying to zap on either 13,19,28 tune failed message appear.
Only reboot solves this

what about the command order?
Which are the right ones?

Please provide some information about the hard- and software used.

Box type: DB800HD
GUI (enigma1/enigma2):enigma2
Firmware version:26.09.2008

Hi to all.
I have 4 DiseqC for 4 satellites. 13,19,28,39
I have configure my 800 as:
LNB : LNB 1
DiSEqC : 1.1
Toneburst : None
Commited DiSEqC command : AA
Fast DiSEqC : yes
Sequence repeat : no
Command order : toneburst, commited
Uncommited DiSEqC Command : None
DiSEqC repeats : None
LOF : Universal LNB

For the 2nd satellite I change the LNB with 2,3,4 and the Commited DiSEqC command with AB,BA,BB

My LNBs are "EDITION QLS-5 quad-LNB".
My DiSEqC are MAXIMUM 4/1

My problem is when i watch on 13 no problem at all. When i change to the others satellites my 800 freeze with "Tune failed" message
A frind of mine gave me one file named "alps_bsbe2.ko", 46,4 KB (47.570 bytes). With this file when i change from 39 to 28 "Tune failed" message appear but after 5-8 seconds i can watch the program. Other times it does not appear anything, till zapping to some channels waiting for signal to appear

What can i do?
Do i have to change anything in the 800 configuration?

The same time, i have 1 DB600 without problems.