I went back to Stable firmware (backup), cause Unstable has problem with HDMI CEC and Panasonic TV HDMI input.
I know about vendor settings, but it just don't work.
To my surprise T2 and LG C/T modules still have no problem?!
Strange, cause LG module is like not detected, but in Tuner configuration it's visible and working without problem.
Beiträge von kkrahv
-
-
I did clean install, cause I had Stable firmware.
I did Service Searching and at least in my case all OK now.
I've sent back the second T2 tuner modul and can't test it anymore at the moment,
but probably they working now together also. -
Actually it's working now
I did clean install and now all 5 tuners are visible. -
No, you don't have problem with upgrade this way.
Maybe you could try install LG tuner to slot B, like obi did? -
I'd like to get only driver, cause I have Stable Image. Is there any solution?
-
Where to find it?
-
It seems well inserted in the connector!
The behaviour is the following: initially i inserted the DVB-C/T2 in slot C and so the LG tuner in the slot B disappeared. Then i swapped the tuners: LG in slot C and DV-C/T2 in slot B and then the LG Tuner in slot C disappeared.
Can it be this is something to do with firmware image? I'm using OPENDREAMBOX 2.2 updated to 15 Octoer 2016!
But i think the author that started this thread has exactly my same problem.
Thanks for support .
Nobody believed me earlier. -
Here is one stable image
-
Maybe is problem with power adapter?
-
Have you tried another USB cable?
-
Ok, then it should work, but I have no more tips for you :(.
-
There is COM3, but I can see you have selected COM4 in DreamUP?
-
Have you installed USB driver?
http://dreambox.de/en/dm-800-hd-se-information -
Try like this:
Telnet in to your box, and issue init 4 command. Then, FTP in, and edit the file /etc/enigma2/settings.
In here, you should find a section called config.ParentalControl.servicepin.0=[/]. After the = sign, will be your pin number... You can edit it there, and then issue the init 3 command to load the box back up.
If you just want to find out what the code is, you can ignore running the init commands, and just find out what the code is and use that. -
Now I have 2x DVB-C/T2 modules in DM7080 and Tuner C1 have no signal.
Antenna signal is ok and connected. Module is shown and configured as Tuner B1 and B2.
B1 and B2 working without problem. If I take Tuner B out, then C will come alive.
Modules are ok, I've tested them by changing.
What may be problem here?See attachments. I've checked everything.
I know and you confirm, that theoretically it have to be working like this, but practically it's not.
Is there anyone, who can test it? Is it problem with Stable image? -
No, C1 not working. There is no signal.
-
It does'nt work. I need 2xSat and 3xT2, but it's not possible with new DVB-C/T2 modules :(.
-
Then I will get 4 tuners and not 5 anyway.
-
Is there any chance to turn one tuner off? Or I have to cut one tuner off?
-
Ok, I understand now. Module is like 2 Tuners and DM7080 can't use/see only one.