Tnx MAxWafer

I had a look at the post but i don't speak German. So i translated the pages and as far as i understand the problem is the diseqc switch. I played with the settings and i found out the best settings for me. They don't solve the problem out but i have less error messages than before.
I changed the "DiSEqC repeats" to 3 and the most important the "Increased Voltage" to yes. Without the "Increased Voltage" set to yes there is no difference no matter what changes i am doing.
The only problem i have now is when i am changing channels from one sat to other very fast. Then i am getting the message. If the change is slow then no problem.

Please provide some information about the hard- and software used.

Box type: 7025+
GUI (enigma1/enigma2): enigma2
Firmware version: ??

your question

I have 2 dishes and 3 lnbs- Hotbird 13E, Eutelsat 16E and Hellas 39E. When changing from channels of one sat to channels of another sat i am getting the error "Tune Failed". I noticed that the signal strength is falling from 8-9 db to 0.01-0.03 db. After few moments i am getting another error which says "No data on transponder (Timeout reading PAT)".
I am the using the latest GP 3.2.

Any solution????