Zitat

Originally posted by tequ69

[...]
I'm wondering where this mA adjusting should be. I can found one value from motor setup screen, but it makes me feel that it's not correct place. It was 50 mA by the default and I tried to adjust it smaller value without huge success.

[...]

That's the right place. With 50mA I had the dish occasionally "flying" past the actual sat and then not been able to lock onto it.

As stated previously, it works without any hitches using either 40mA or 35mA (have the latter set currently).

Still get the "Tune Failed" if moving from e.g. 28.2E to 19.2E (not that it bothers me) but then goes onto lock onto the appopriate sat. I believe this is probably a hard-coded timeout messgae i.e. after x secs.

Edit : Stab motor.

thx its really appreciated.

Well it turns out to be an "unknown gremlin"; as almost everytime this morning it is booting up into the second stage loader...

_i honestly am doing nothing different from yesterday - cie la vie_

...up and running - thx.

Box type: DM7025
GUI (enigma1/enigma2): Engima2
Firmware version: Engima v2.0.0120200601121943

Hi
I am unable to get my new DM7025 to boot into the "second stage loader" so I can reflash my box.

The following instructions have been carefully followed : http://www.dream-multimedia-tv.de/dm7025/eng_browser.php.
However, when "Pressing and holding the lower frontpanel button" and "switching the unit on" from the power on/off button (at the back of the unit) it always comes up with :

myDM7025's IP-Address
Boot #41 (20060111)

and just "seems" to hang...

Unfortunately, my laptop/notebook does not have a COM port so I cannot try with DreamUP.

Any suggestions/help... Would be greatly appreciated.

ciao for now,

PDM

PS - I have a DM7020 as well and have never had a problem before using this approach.