Please provide some information about the hard- and software used.
Box type: DM800
GUI (enigma1/enigma2): E2
Firmware version: [Moderator] Image is in violation of the Boardrules [/Moderator]
Switch: Satconn 1/10 mode 2
Settings: Henksat 1 dec not modified
Can some explain this behaviour ?
I suddenly get "PID not found" errors on BBC2 and 3 while this did work correctly. Played around with settings found on this board without any succes. Same switch configuration used by Henksat does not have any problems. (BTW: Have similar behaviour on other satellites)
Analysis: Whatever special configuration settings I use on BBC channels
I always get a "PID not found" error if I switch from BBC HD to BBC1 and BBC2 going down the list (but I always get to see the channel after the error message has disappeared !!).
When I go up from CBBC towards BBC3, BBC2, BBC1 and BBC HD I have instant views without any errors or what so ever.
This is very unlogical for me.
Can some explain this behaviour ? And is there a solution ?