Dreambox DM600PVR FIRST STAGE 1.6 {BO2345} 2ND STAGE OK, build #67 (20081024) 0.000 - fp init 0.001 - ca init 1.750 - load config 1.808 - config loaded. * press [S] to enter setup no CF card detected! no OLED found! BOOT #67(20081024) - NAND PROBE: ad 75 : 16kb +++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++ +++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++ +++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++ +++++++++++++++++++++++++++++++++++++++++++++++++++ dreamupd initialized Scanning JFFS2 FS: . done. /flash/bootlogo.elf /flash/zImage.elf loaded at: 00500000 00672244 board data at: 00670124 00670244 relocated 0066F8AD avail ram: 006730 Linux/PPC load: console=ttyS0,115200 ip=10.0done. Now booting the kernel Linux version 2.6.12 (ghost@Client) (gcc version 3.4.4) #1 Mon Apr 6 14:51:51 CE 0.0.203 nfsroot=10.0.0.1:/home/tmbinc/mips/target root=/dev/nfs rw PID hash tab Dentry cache hash table entries: 16384 (order: 4, 65536 bytes) Inode-cache hates) k highmem) Mount-cache hash table entries: 512 NET: Registered protocol family 16 SCSI subsystem initialized u) devfs: boot_options: 0x1 JFFS2 version 2.2. (NAND) (C) 2001-2003 Red Hat, Inc. Serial: 8250/16550 driver $Revision: 1.90 $ 7 ports, IRQ sharing disabled ttyS0 at MMIO 0x0 (irq = 21) ttyS2 at MMIO 0x0 (irq = 22) is a 16550A io scheduler noop registered io scheduler (becker@scyld.com) Last modified Nov 1, 2000 by Paul Gortmaker NE*000 etherirq 25: nobody cared! Call trace: [c003cd9c] __report_bad_irq+0x34/0xac [c0do_IRQ+0x38/0x98 [c0003548] ret_from_except+0x0/0x18 [c003cb44] setup_ [c02ffb60] ne_probe+0xd8/0x120 [c02ff228] probe_list2+0x60/0xbc [c02ff340l_thread+0x44/0x60 handlers: [] (ei_interrupt+0x0/0x3f0) Disabling 5. tun: Universal TUN/TAP device driver, 1.6 tun: (C) 1999-2004 Max Krasnyanskform E-IDE driver Revision: 7.00a2 ide: Assuming 50MHz system bus speed for PIOtected IOADDR: f3000000/f4000000 DMA addr: fce00000 using irq 26 NAND device: Manufacturer ID: 0xad, Chip ID: 0x75 (Unknown NAND 32MiB 3,3V 8-bit Creating 4 MTD partitions on "NAND 32MiB 3,3V 8-bit": 0x00000000-0x02000000 : "0 : "boot partition" 0x00400000-0x02000000 : "root partition" mice: PS/2 mouse device common for all mice i2c /dev entries driver IBM IIC driver v2.1 ibm-iic0: using standard (100 kHz) mode NET: Registered protocol family 2 IP: routing cache hash table of 512 buckets, 4Kbytes TCP established hash table entries: 4096 (order: 3, 32768 bytes) TCP bind hash table entries: 4096 (order: 2, 16384 bytes) TCP: Hash tables configured (estabistered protocol family 17 IP-Config: Guessing netmask 255.0.0.0 IP-Config: Complete: device=eth0, s-domain=(none), bootserver=255.255.255.255, rootserver=10.0.0.1, rootpath03/2 on 10.0.0.1 portmap: server 10.0.0.1 not responding, timed out Root-NFS: Unable to get nfsd port number from serverng up port of RPC 100005.1 portmap: server 10.0.0.1 not responding, timed out Root-NFS: Unable to get mounmount: server 10.0.0.1 not responding, timed out Root-NFS: Server returned erroVFS: Unable to mount root fs via NFS, trying flopp y. VFS: Cannot open root devic - not syncing: VFS: Unable to mount root fs on unkno wn-block(2,0) <0>Rebooting in 180 seconds..