=~=~=~=~=~=~=~=~=~=~=~= PuTTY log 2016.12.11 09:33:23 =~=~=~=~=~=~=~=~=~=~=~=
CPU 01
Dreambox DM9 00

AVS init...
AVS init OK
AVS load:select_image: addr_offset: 00051000 part_offset: 00000000 bootStatus: 2a002b00
AVS load_code offset =00051000
LOADED
AVS: overtemp mon ON

single board
select_image: addr_offset: 00055000 part_offset: 00000000 bootStatus: 3d2b2500
MEMSYS-STD
SHMOO 02010000 BLD:11138M HW:hpf0_b1p6 V:2.1.0.0
MCB: FLEX
AVS start:status=000000ff
STB: Current voltage=0000038e(910)
 temperature=0000c1fc(49660)
 PV=0000034f(847)
 MV=0000038e(910)
AVS FW rev=30333278 [0.3.2.x]
OK
DDR0: !@ ffe0e780 <= ffe0df10 MEMSYS-0 @ f1100000 OK
DDR1: =@ ffe0e780 <= ffe0df10 MEMSYS-1 @ f1180000 OK
Sdram Scramble OTP = 0x00000001 
Sdram Scramble OK
select_image: addr_offset: 00020000 part_offset: 00000000 bootStatus: 1b25252b
BFW load mode OTP = 0x0000000f 
bfw_hash_locked = 0x00000000 
BFW key3 OK, BFW load OK
BFW v2.1.0
COPY CODE... DONE
MICH: disable success
SSBL
PINMUX
CACHE FLUSH OK
MMU ON
CACHE FLUSH OK
_fbss  07080cd0
_ebss  0713dd70
_end   0713dd90
HEAP @ 07200000
STACK @ 09300000
ARCH: CONFIG OK
CLR BSS 07080cd0 to 0713dd70 OK
CLR SRAM  OK
CACHE FLUSH OK
CPU CLKSET OK
GO!

    ,/    
  ,'/___, BOLT v1.18 v1.18 LOCAL BUILD
.'__  ,'  (2016-10-31 21:04:46 cynric@cynric-VirtualBox)
   /,'    Copyright (C) 2016 Broadcom
  /'      

Board: BCM97252SSFF
SYS_CTRL: product=72521, family=7439b1, strap=000000b2, 
otp @ 0xf0404030 = 0x822000e0: en_cr(0x00000060) en_testport(0x00000080) macrovision_disable(0x02000000) moca_disable(0x80000000) rv9_disable(0x00200000) 
otp @ 0xf0404034 = 0x00000021: moca2_disable(0x00000001) rfm_disable(0x00000020) 
CPU: 2x B15 [420f00f3] 1719 MHz
SCB: 432 MHz
DDR0 @ 1067MHz, DDR1 @ 1067MHz
RESET CAUSE: 0x000001 power_on (1 of 23 possible causes)
CS0: SFDP SPI, 32MB, 64kB blocks, 64kB erase block, 256B pages
CS1: NAND: unrecognized ID: 0x76ffff 0xffffffff
RTS0: 0x1101004, 256 clients, ok
RTS1: 0x1181004, 256 clients, ok
BOX MODE: 5
card if inited
set pwm to 0/255
disp id 5420
load image
AVS: park check
AVS: temperature monitoring enabled
AVS: STB: V=0.912V, T=+51.121C, PV=0.847V, MV=0.910V, FW=30333278 [0.3.2.x]
USB otp=00000040
USB @ 0xf0470200: IPP is active low, IOC is negative polarity
init fp
found card in unknown state
cannot read T1 header
error in receive
error during t1 transfer
cannot read fabca-cert
set pwm to 200/255
TPM error. Please contact Dreambox support