Beiträge von tonv

  • crash dm900

    Hi m0rphU,


    I didn't know about the ability to make a bootlog, but still, how would you get this box going again just by looking at a log? Is there any way to manipulate the DM900 using this micro USB interface at the back? The DM site mentions it can be used for flash rescue, but is there any information how to actually do this? (or is this only available to DM personnel?)


    Sent from my SM-P900 using Tapatalk

  • crash dm900

    I don't believe there is another way to do some sort of factory reset, so if Blefarine can't get beyond this "!" then there is no way to read any log, it is simply dead... Unless someone knows a way to this hard reset, I've never read about that anyway...



    Sent from my SM-P900 using Tapatalk

  • crash dm900

    Sorry, but I have no more suggestions, booting into recovery is the most basic function, that should enable you to install a brand new image, if the bootstrap is missing or corrupted then all I can suggest is to return your DM900 for repair :frowning_face:


    Sent from my SM-P900 using Tapatalk

  • crash dm900

    Just to be sure: did you did the boot like in this Youtube movie:

    Externer Inhalt www.youtube.com
    Inhalte von externen Seiten werden ohne Ihre Zustimmung nicht automatisch geladen und angezeigt.
    Durch die Aktivierung der externen Inhalte erklären Sie sich damit einverstanden, dass personenbezogene Daten an Drittplattformen übermittelt werden. Mehr Informationen dazu haben wir in unserer Datenschutzerklärung zur Verfügung gestellt.
    ? If that doesn't get you to rescue mode it may be end-of-story (and send it back for repair)... Just make sure, like m0rphU suggests, it is cabled correctly and there is a DHCP server in the network...


    Sent from my SM-P900 using Tapatalk

  • crash dm900

    Sound like you're not succeeding in getting the box into recovery mode... Here it is explained: http://wiki.blue-panel.com/index.php/Rescue_Loader. Point is to power on using the power switch at the back and once the red light goes on at the front, push the touchbutton at the front and keep pushing it until it start flashing red/blue/red/blue, Than it is in rescue mode and will show that in the display. Then you can access it with a browser again or load an image from USB (front works for me). Hope this helps... Again, timing is crucial, only touch the front touchbutton AFTER you power on, but don't wait too long or it will no longer boot into rescue (it's only a fraction of a second...) Good luck!


    Sent from my SM-P900 using Tapatalk

  • crash dm900

    Have you tried booting into rescue mode? Powering on with the power switch on the back and holding the touch key at the front? (timing is crucial, you may need to try this a few times). This should enable you to install a new image from USB...



    Sent from my SM-P900 using Tapatalk