Please provide some information about the hard- and software used.

500s:
GUI (Gemini):
Firmware 3.20:

your question

Hi All

New here and I need some urgent help!

I flashed my 500s yesterday with [Moderator] Fremdimage, verstoesst gegen die Boardregeln [/Moderator] 3.20 via the Dcc I followed the instructions on the Dcc and went into the menu and pressed manual software update, the receiver erased the flash and installed the new one, but afterwards it automaticlly powered off so no light red or green showed on the front and when I reconnected the mains the green light shows for 2 mins and then if powers off again, I have tried many times to enter the menu but it will not accept any comands from the remote, nor will it do anything if I press the standby button on the front panel.

Help have I messed up the box or is it a faulty unit?

Thanks