i have problem in dreambox 520 hd it suddenly stop working and blinking red i flash new img open ATV 6.1 during flashing it gives cannot read CA consider updating rescue loader and after flashing dreambox empty tuner A and B and also cannot recognize usb stick or hard disk i update rescue loader to 103 but still same problem what is the cause and how to solve?
empty tuner and tuner b after installation open ATV 6.1
-
-
Hello.
wrong Forum, go to OpenATV Forum , only support for original Images from here: http://dreamboxupdate.com/
-
l already download and flash original img from dreamboxupdate.com/ after flashing dreambox 520 did not boot and stop at dreambox logo flashing red light so i reflash again pli and same problem then i flash HD freaks also same problem (empty tuner) i flash dream elit and merine but stop at logo and did not boot
-
so with pli and openATV and hd freaks boots but with empty tuner problem and with original img ,dream elite , merine didnot boot and stop at logo flashing red light
-
Well then, it seems the tuner is defective (or the surrounding HW controllung it). Since this is controlled by the I2C bus, it is probably 'locked'. This can be caused by a short circuit (did you connect the LNB cable whilst the unit was on? Thunderstorm nearby whilst in operation?). Not much you can do apart from sending it in for repair..
-
thank you mimisiku may be this is the cause , i will send it for repair.
-
bootlog knows much more than leds.
-
i try putty for bootlog using serial cable(mini usb ) but when i turn on dreambox it make my laptop to shutdown
-
If (and I say IF) the I2C bus is locked there will be no bootlog possibility as all inter-communication between internal HW is lost.. Only SoC,cache and direct ported RAM/ROM is accessible.
-
IF it makes your laptop shut down (and not crashing) then your are shortening the USB bus.